HOT TO CUT & FIX A SUP PADDLE
How To Cut and Fix a SUP Paddle Together
This is a how to guide for how to cut an SBS fixed length paddle fallow the guide step by step or watch the video to create your perfect paddle.
Supplies Needed:
* Hacksaw * Masking Tape * Sanding Block * Medium Grit Sandpaper * Tape Measure
* Fine Tip Permanent Marker * Dust Mask (Optional) * 5 Minute Epoxy * Stir Stick * Mixing Tray
1) To measure paddle length, stand the paddle Upright next to you with the tip of the blade touching the ground.
2) Using a fine tip permanent marker, mark a line on the shaft where you will make the cut.
WARNING: Make sure to compensate for the additional length with the handle installed.
3) Wrap a strip of masking tape around the shaft where you put your mark to prevent splintering while cutting.
4) Using the hacksaw, cut the shaft. Note: Paddle length is a personal preference. We recommend the total paddle length to be approximately 8” to 12” above head level, including the additional length with the handle installed.
* A longer length shaft is recommended for racing and flat water cruising.
* A shorter length shaft is recommended for wave riding.
5). Using the sanding block, sand the end of the shaft flat and smooth out the edge. Remove the masking tape
Handle & Blade Installation
1) Using the mixing tray and stir stick, mix the epoxy thoroughly. And insert heat shrinking loop over paddle shaft
2) Coat the inside of the handle with the epoxy. Repeat this stage with the blade
3) Insert the handle onto the shaft. Line up the flat side of the handle with the outward facing blade while the epoxy is still wet.
4). Line up the flat side of the handle with the outward facing blade while the epoxy is still wet.
5) Once the handle has dried, drip a bead of epoxy around handle connection to prevent leakage. Wipe off any excess resin
6) Slide heat shrinking loop over blade and shaft connection and apply heat until tight
After this, your paddle should be complete and ready to youse, have fun and see you in the water.
Related Posts
The Wipe Out That Nearly Killed Kelly Slater
The Wipeout that Nearly killed Kelly Slater >>>> Yes, even the surf gods like Kelly Slater can have a close call from time to time, the 11-time world champion Professional surfer Kelly Slater talks about his experience with the wave in France that almost...
How To Fix A Surfboard Ding
How To Repair A Surfboard Fast We have all been there… you're travelling through a far-off exotic country, you are just about to go out for a surf and the waves look great, but you find out you got a ding from your last session or you damage your board on the way...
5 Weird Superstitions Most Surfers Believe In
5 Weird Superstitions Most Surfers Believe In Superstitions can be a weird thing that might not have any real world or scientific evidence to back them up, but people still believe that walking under a ladder, or meeting a black cat in your path can give you bad luck,...
Why I Love Surfing In The UK !!
One of the best cinematic surf clips I think we have seen this year representing the UK surf scene If you a surfer in the UK you might know the hard grind of the winter swell freezing cold water and wind almost no sun and full length 5'4 wetsuits will all the...
WHY KELLY SLATER WENT VEGAN
The King Of Surfing Goes Vegan "Kelly Slater" Kelly Slater the 11-time world champ of surfing has always been known for eating pretty healthy, and if you watch any interview with him talking about food by god he knows a lot about health and nutrition. But more...
6 Reasons The Pea Shooter Is Our Ultimate Fun Board
6 Reasons The Pea Shooter Is Our Ultimate Fun Board The Peashooter is one of our most fun boards to surf its got so much potential in any conditions and can be especially fun for a beginner to intermediate surfer. Here are our 6 top reasons the pea shooter is our...
